Ultrasonic titanium rod cleaning machine introduction:
Pharmaceutical manufacturers or chemical manufacturers, titanium rods, stainless steel rods, and nickel rods used for water filtration, air filtration, or other filtration are generally only washed manually in tap water and then used again. The cleaned titanium rods The filtering effect is far from the requirements of use. The ultrasonic titanium rod cleaning machine made by our company adopts the method of internal flushing and external washing to clean the titanium rod. , External washing - ultrasonic cleaning of the outside or voids of titanium rods. After the ultrasonic wave loosens the stains and scales on the titanium rod, the flushing water and compressed air in the inner flush are washed out again, and the effect is clean and thorough.
Ultrasonic titanium rod cleaning machine parameters:
1. Scope of application: titanium rods, stainless steel rods, nickel rods, etc.
2. Cleaning range: 10 inches to 40 inches
3. Cleaning capacity: 1-16 pieces
4. Ultrasonic power: 1—4KW
5. Speed: 0.5 rpm (adjustable)
6. Voltage: 220V 50HZ
Ultrasonic titanium rod cleaning machine feature:
1. The fully automatic type adopts 7-inch touch screen display (optional), with clear picture and simple operation.
2. Equipped with a timing device, set the cleaning time as needed.
3. During the cleaning process, the titanium rod can rotate slowly, and the speed is adjustable.
4. Using high-performance transducer and unique ultrasonic generator, the cleaning power is strong and the performance is stable.
5. The equipment is equipped with a high-pressure water inlet, which can backwash the titanium rod.
6. There is an automatic heating constant temperature device, and the temperature control range is from room temperature to 100 °C (optional).
